Earthquake E43 Manuel d'utilisateur télécharger pdf (Page 9)

Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 9

Operator's Manual

Earth Auger Powerhead E43/E43CE

COOLING FINS

Cooling ns, air inlets and linkages must be free from any debris

before each use.

AIR FILTER

Never run engine without air cleaner properly installed. Added wear

and engine failure may occur if air cleaner is not installed on engine.

Service air cleaner every 3 months or after 20 hours of operation.

Clean lter daily in extremely dusty conditions.

MAINTENANCE AND STORAGE

POWER AUGER MAINTENANCE

1. The gear case has 4 oz. of grease installed at the factory. It is rec-

ommended that once a year the gear case be split and the grease

level checked. Add grease only if level of grease is below top of the

gears. DO NOT OVERFILL.

 

3. For cold weather operation, store the unit in a cool environment.

Transferring the unit from a warm to a cold place can cause the

build up of harmful condensation.

4. If blade performance decreases, turn unit o and disconnect spark

plug wire. Carefully inspect cutting edge of blade for any signs of

wear. If blades show any of these signs, they need to be sharpened

or replaced.

ENGINE MAINTENANCE

Please read the maintenance schedule and observe these recommen-

dations to extend the life of your engine.

Good maintenance is essential for safe, economical, and trouble-free

operation. It will also help reduce air pollution. To help you properly

care for your engine, the following pages include a maintenance

schedule, routine inspection procedures, and simple maintenance

procedures using basic hand tools. Other service tasks that are more

difficult, or require special tools, are best handled by professionals

and are normally performed by a technician or other qualified

mechanic.

Maintenance, replacement or repair of the emissions control devices

and systems may be performed by any non-road engine repair

establishment or individuals. However, items must be serviced by an

authorized dealer to obtain "no charge" emissions control service.

The maintenance schedule applies to normal operating conditions. If

you operate your engine under unusual conditions, such as sustained

high-load or high-temperature operation, or use in unusually wet or

dusty conditions, consult your servicing dealer for recommendations

applicable to your individual needs and use.

IMPORTANT

NEVER TWIST AIR FILTERS WHEN CLEANING. ALWAYS

PRESS.

CAUTION

TO PREVENT ACCIDENTAL STARTING:

ENGINE MUST BE TURNED OFF AND COOL, AND SPARK

PLUG WIRE MUST BE REMOVED FROM SPARK PLUG BEFORE

CHECKING AND ADJUSTING ENGINE OR EQUIPMENT.

TEMPERATURE OF MUFFLER AND NEARBY AREAS MAY EX

CEED 150º F. 65º C. AVOID THESE AREAS.

CHECK AUGER OFTEN FOR LOOSE NUTS AND BOLTS. KEEP

THESE ITEMS TIGHTENED.

NEVER STORE ENGINE WITH FUEL IN THE TANK INSIDE A

BUILDING. POTENTIAL SPARKS MAY BE PRESENT FOR IGNI

TION OF FUEL AND FUEL VAPORS.

ANY MAINTENANCE AND REPAIR ON THE ENGINE AND AU

GER MUST ALWAYS BE DONE BY AN ADULT.

ENGINE MUST BE SHUTOFF, COOL, AND SPARK PLUG WIRE

REMOVED BEFORE ANY REPAIR OR MAINTENANCE CAN BE

DONE.

MAINTENANCE ITEM

Every 8

hours

(daily)

Every 20

hours or

seasonally Yearly

Clean Engine and Check Bolts & Nut X

Air Filter Check X

(See Air Filter section) Clean * X

Replace X X

 Check/

Adjust

(See Spark Plug

section on Page 11)

Replace X

* Service more frequently under dusty conditions

MAINTENANCE SCHEDULE

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 91 92

Commentaires sur ces manuels

Pas de commentaire

Earthquake E43 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour les appareils électriques Earthquake E43