Earthquake 9060300 Manuel d'utilisateur télécharger pdf (Page 10)

Operator’s Manual

Chipper Shredders

10 Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5

Attaching Hopper Extension To Hopper

For European models only (14268, 9060140, and 12547)

Tools Required:

• 5/32” Hex drive wrench (i.e: allen wrench)

• 7/16” Wrench for 1/4-20 ange nut

NOTE: Assemble extension before adding fuel or engine

oil.

(1). To attach the hopper extension:

a. Before bolting the handle into position, slide one

hopper extension half (1709470) over the rim of the

hopper. The groove around the inside bottom of the

hopper extension should t over the rim around the

top of the hopper. SEE FIGURE 4

b. Ensuring the hopper and hopper extension holes are

now aligned along the top rim of the hopper, place

a 1/4-20 x 3/4 bolts (1960507) through each of the

four holes in the extension and hopper. Secure bolts

in place with the included 17/64 x 5/8 at washers

(1921319) and 1/4-20 ange nuts (1930642). DO NOT

fully tighten hardware at this point. SEE FIGURE 4

c. Bolt handle into position using appropriate hardware.

Lay the unit down, resting the handle on a piece of

cardboard to prevent scratching.

d. Follow Step 1 to install the second extension half to

the opposite side of the hopper. Again, the bottom

groove of the hopper extension should t over the rim

at the top of the hopper. Align the bolt holes between

the top of the hopper and bottom of the hopper

extension and insert hardware. SEE FIGURE 5

e. Place a 1/4-20 x 3/4 bolt (1960507) in each of the

three holes along the two seams of the joined hopper

extension halves. Secure each bolt with a at washer

and ange nut. DO NOT fully tighten. SEE FIGURE 6

f. Place bolt through each of the two holes on top of the

joined hopper extension. Secure with at washer and

ange nut. SEE FIGURE 7

g. Once all hardware has been inserted, use 5/32” allen

wrench and 7/16” wrench to fully tighten all hardware,

including those around hopper rim and along the

hopper extension seams.

FIGURE 4

FIGURE 5

FIGURE 6

FIGURE 7

FLANGE

NUT

FLAT

WASHER

1/4-20 BOLT

HOPPER

EXTENSION

14306-001R1

HOPPER

EXTENSION

1/4-20

BOLT

FLANGE

NUT

FLAT

WASHER

14306-0009R1

1/4-20

BOLTS

14306-0011R1

1/4-20

BOLTS

14306-0012R1

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Earthquake 9060300 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Machines spéciales Earthquake 9060300