Earthquake 9800B Manuel d'utilisateur télécharger pdf (Page 9)

Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 9

Operator's Manual

Two-Person Earth Auger Powerhead 9800 Series

MAINTENANCE AND STORAGE

POWER AUGER MAINTENANCE

1. The gear case has 4 oz. of grease installed at the factory. It

is recommended that once a year the gear case be split and

the grease level checked. Add grease only if level of grease is

below top of the gears. DO NOT OVERFILL.

2. Keep all screws, nuts, and bolts tight.

3. For cold weather operation, store the unit in a cool environ-

ment. Transferring the unit from a warm to a cold place can

cause the build up of harmful condensation.

4. If blade performance decreases, turn unit o and disconnect

spark plug wire. Carefully inspect cutting edge of blade for

any signs of wear. If blades show any of these signs, they need

to be sharpened or replaced.

5. Always allow muer to cool before lling fuel tank.

6. When storing for over one month, use gas stabilizer in fuel.

7. Do not ll gas tank indoors or when engine is running or is

hot.

CAUTION

TO PREVENT ACCIDENTAL STARTING:

ENGINE MUST BE TURNED OFF AND COOL, AND

SPARK PLUG WIRE MUST BE REMOVED FROM SPARK

PLUG BEFORE CHECKING AND ADJUSTING ENGINE

OR EQUIPMENT.

CHECK AUGER OFTEN FOR LOOSE NUTS AND BOLTS.

KEEP THESE ITEMS TIGHTENED.

NEVER STORE ENGINE WITH FUEL IN THE TANK IN

SIDE A BUILDING. POTENTIAL SPARKS MAY BE PRES

ENT FOR IGNITION OF FUEL AND FUEL VAPORS.

ANY MAINTENANCE AND REPAIR ON THE ENGINE

AND AUGER MUST ALWAYS BE DONE BY AN ADULT.

ENGINE MUST BE SHUTOFF, COOL, AND SPARK PLUG

WIRE REMOVED BEFORE ANY REPAIR OR MAINTE

NANCE CAN BE DONE.

ENGINE MAINTENANCE

Please read your engine manual and observe these recommen-

dations to extend the life of your engine. Your engine manual

provides detailed information and a maintenance schedule for

performing the following tasks:

1. Check oil level every ve (5) operating hours and before each

use.

2. Change oil after first two (2) operating hours and every

25 operating hours thereafter, more often if operated in

extremely dusty or dirty conditions. Change oil while engine

is still warm from recent running.

3. Frequently remove dirt and debris from cooling ns, air intake

screen, levers and linkage. This will help ensure adequate

cooling and correct engine speed.

4. Check air cleaner.

5. Check spark plug yearly or every 100 operating hours.

6. Check engine and auger often for loose nuts and bolts.

Good maintenance is essential for safe, economical, and trou-

ble-free operation. It will also help reduce air pollution. To help

you properly care for your engine, read your engine manual

and pay close attention to the maintenance schedule, routine

inspection procedures, and simple maintenance procedures.

Other service tasks that are more difficult, or require special

tools, are best handled by professionals and are normally per-

formed by a technician or other qualified mechanic.

Maintenance, replacement or repair of the emissions control

devices and systems may be performed by any non-road

engine repair establishment or individuals. However, items

must be serviced by an authorized dealer to obtain "no

charge" emissions control service.

The maintenance schedule applies to normal operating condi-

tions. If you operate your engine under unusual conditions,

such as sustained high-load or high-temperature operation, or

use in unusually wet or dusty conditions, consult your servic-

ing dealer for recommendations applicable to your individual

needs and use.

TRANSPORTING YOUR EARTH AUGER

1. Never transport engine inside an enclosed space or vehicle.

Fuel or fuel vapors may ignite causing serious injury or death.

2. If fuel is present in the fuel tank, transport in an open vehicle

in an upright position.

3. If an enclosed vehicle must be used, remove gas into an ap-

proved red fuel container. DO NOT siphon by mouth.

4. Run engine to use up the fuel in the carburetor and fuel tank.

Always run engine in a well ventilated area.

5. Wipe away any spilled fuel from engine and earth auger. Allow

to dry.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Earthquake 9800B Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Fournisseurs d'énergie Earthquake 9800B