EarthQuake CS4518B Manuel de l'opérateur télécharger pdf (Page 14)

Page 14

NOTE

Pay attention to the correct direction of the saw chain.

1：Moving direction

4. Mount the guide bar then ﬁt the saw chain around the

bar and sprocket.

5. Fit the chain tensioner nut into the lower hole of the guide bar,

then install the chain cover, and fasten the mounting nut to

ﬁnger tightness.

6. While holding up the tip of the bar, adjust the chain tension by

turning the tensioner screw until the tie straps just touch the bottom

side of the bar rail.

7. Tighten the nuts securely with the bar tip held up 10 ft lbs (100-

130 inch lbs).

Then check the chain for smooth rotation and proper tension while

moving it by hand. If necessary, readjust with the chain cover loose.

8. Tighten the tensioner screw.

(1) Loosen

(2) Tighten

(3) Chain tension adjusting screw

IMPORTANT

It is very important to maintain the proper chain tension. Rapid wear of the guide bar or

the chain coming off easily can be caused by improper tension. Especially when using a

new chain, take good care of it since it should expand when ﬁrst used.

Installing Guide Bar / Chain

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 34 35

Pas de commentaire

EarthQuake CS4518B Manuel de l'opérateur Page 14