EarthQuake CS4518B Manuel de l'opérateur télécharger pdf (Page 7)

Page 7

(f). The screw under the "H" stamp is The High-speed adjustment

screw. The screw under the "L" stamp is The Slow-speed adjustment

screw. The screw up the "T" stamp is the Idle adjustment screw.

Position: upper-left of the rear handle

NOTE

Carb is set at factory.

Special tools are required for carb adjustment and can only be

performed by a qualiﬁed service center.

Severe engine damage or personal injury may occur if proper

procedures are not followed.

(g). Shows the directions that the chain brake is released (white arrow)

and activated (black arrow).

Position: Front of the chain cover

(h). Shows the direction of the saw chain installation.

Position: Front of the chain cover

Symbols on the Machine

1 2 3 4 5 6 7 8 9 10 11 12 ... 34 35

Pas de commentaire

EarthQuake CS4518B Manuel de l'opérateur Page 7