EarthQuake CRT series Manuel de l'opérateur télécharger pdf (Page 15)

Operator’s Manual

Front Tine Tiller 3365 Series

Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 CST

TROUBLESHOOTING AND REPAIR

TROUBLESHOOTING GUIDE

While normal care and routine maintenance will extend the life

of your rototiller, prolonged or constant use may eventually

require that service be performed to allow it to continue oper-

ating properly. The troubleshooting guide below lists the most

common problems, causes and remedies.

PRACTICE SAFETY AT ALL TIMES. ENGINE MUST BE TURNED

OFF AND ALLOWED TO COOL, AND SPARK PLUG WIRE MUST

BE DISCONNECTED AND SECURED BEFORE ATTEMPTING

ANY MAINTENANCE OR REPAIR.

FAILURE TO COMPLY WITH THIS SAFETY

REQUIREMENT

CAN RESULT IN SERIOUS PERSONAL INJURY TO YOU OR

BYSTANDERS.

WARNING

PROBLEM REMEDY/ACTION

Engine will not start • Addgastogastank.

• Connectsparkplugwiretosparkplug.

• Throttlemustbepositionedatchokeforacoldstart.

Enginerunsrough,oodsduringoperation • Cleanorreplaceaircleaner.

Engine is hard to start • Drainoldfuelandreplacewithfresh.Usegasstabilizer

at end of season.

• Makesuresparkplugwireissecurelyattachedtospark

plug.

• Drivesafetycontrollevermustbereleasedtoneutral 

to start the engine.

Engine misses or lacks power • Raisethetinesforshallowtillingbyraisingthedepth 

regulator lever.

• Cleanorreplaceaircleaner.

• Impropercarburetoradjustment,taketoauthorized  

engine service center.

• Replacesparkplugandadjustgap.

• Drainandrellgastankandcarburetor.

Engine will not stop when throttle control is positioned at stop • Seeenginemanualtocheckandadjustthrottlelinkage.

Tiller moves forward during starting • Drivesafetycontrollevermustbereleasedtoneutral 

to start the engine.

Tiller is dicult to control when tilling

(machine jumps or lurches forward)

• Lowerenginespeedinhardground.

• Raisethetinesforshallowertillingbyloweringthe  

depth regulator lever.

Belts squeal in neutral •Adjustforwardbeltguide:

 - turnengineoandallowmuertocool

- disconnect spark plug wire and secure from spark plug

- pull down on drive safety control lever

- manually bend forward belt guide so there is 1/16 inch

or less clearance between belt guide and belt

- replace spark plug wire

Belts squeal in forward operation •Turnengineoandallowmuertocool.

•Disconnectsparkplugwireandsecurefromsparkplug.

•Releasedrivesafetycontrollevertoneutral.

•Adjustengagecable.

•Replacesparkplugwire.

Excessive heat build up in transmission/tine area during tilling •Removevegetation.

•Checktransmissionuidandllifneeded.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

EarthQuake CRT series Manuel de l'opérateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Mini-faucheuses EarthQuake CRT series